Inside the case

Reseat Your Graphics Card to Fix Display Problems

10 minsIntermediateTools neededVideo

If your graphics card has worked even slightly loose in its slot, it can cause blank screens, visual glitches and instability. Reseating it takes about ten minutes and gives your GPU a clean, solid connection to the motherboard. Here's how to do it properly.

Watch the steps

Tools needed

  • Phillips screwdriver

Why reseat your graphics card?

  • No display or glitches: a blank monitor, flickering or on-screen artefacts can all be caused by a GPU that isn't making full contact.
  • Performance dips: a secure connection helps the card run at its full potential and stay stable under load.
  • Random disconnects: a properly seated card keeps a steady connection to the motherboard, so it won't drop out mid-session.
  • Movement in transit: bumps and vibration during delivery can nudge the card slightly out of its slot.

In most cases, a quick reseat is all it takes to sort these out.

Steps to reseat your GPU

  1. Step 1 of 5

    Shut down, unplug and open up

    Have a Phillips screwdriver ready, as most graphics cards are screwed to the case.

    Shut down your PC, unplug it from the wall and disconnect any monitors from the GPU. This gives you room to work and keeps your display cables from getting damaged.

    Then take off the side panel. Depending on your case, it may use screws or simply slide off. If you're not sure, check your case manual.

    WarningNever work inside a PC that's still connected to power.
  2. Step 2 of 5

    Unplug the GPU power cables

    Locate your GPU. It's normally the largest card sitting in one of the motherboard's PCIe slots, with a row of display ports facing out the rear of the PC.

    Unplug the power supply (PSU) cables that connect to the card, usually on its top edge or its side.

    TipMost connectors have a small latch. Squeeze it before pulling, and pull on the plug rather than the wires.
  3. Step 3 of 5

    Unscrew the GPU

    Lay the PC down on its side.

    Undo the screws securing the GPU to the case. Keep them somewhere safe, because they go back in shortly.

  4. Step 4 of 5

    Remove and reinsert the GPU

    Press the retention clip at the end of the PCIe slot to release the card, then lift it straight out, holding it by the edges.

    Line it back up with the slot and press down firmly and evenly until the retention clip clicks back into place.

    WarningDon't rock the card from side to side or force it. If it won't seat, lift it out and realign it.
  5. Step 5 of 5

    Reconnect the GPU and your PC

    Plug the power cables back into the GPU and push each connector in firmly so it's fully seated.

    Refit the side panel, stand the PC back up, reconnect your monitors and power cable, and switch it on.

What's next?

When your GPU is reseated, watch your PC to see whether the problem returns. If it does, try these guides next.

This guide can help with

Need a hand?

If you're still stuck or want a second opinion, get in touch. Our team is always happy to help.